Step 1; When Driving; Complete the programming within 30- Page 244



If the indicator light flashes rapidly
in green, firmly press and hold the
Homelink button and release it after
two seconds have passed. Repeat
this process up to three times to
complete the programming. The
device becomes operational and
programming is complete. If the
device does not operate, go to the
next step.

5. At the garage door opener receiver

(motor-head unit) in the garage, locate
the “learn” or “smart” button. This can
usually be found where the hanging
antenna wire is attached to the
motor-head unit.

6. Firmly press and release the “learn” or

“smart” button. (The name and color
of the button may vary by
manufacturer.)

NOTE

Complete the programming within 30
seconds.

7. Return to the vehicle and firmly 

press

and 

hold

 the Homelink button, and

then 

release

 it after two seconds have

passed. Repeat the “

press/hold/

release

” sequence a second time, and,

depending on the brand of the garage
door opener (or other rolling code
equipped device), repeat this sequence
a third time to complete the
programming process.
Press the programmed HomeLink
button and make sure that the
HomeLink System operates.

8. If the status indicator arrows are

flashing, refer to Garage Door
Two-Way Communication.

Indicator Light

NOTE

To program the remaining two HomeLink
buttons, go back to 

Step 1

 of

Programming the HomeLink System and
repeat the procedure.

For questions or comments, please contact

HomeLink at www.homelink.com

 or

www.youtube.com/HomeLinkGentex

, or

the HomeLink toll-free hotline at
1-800-355-3515 (for calls placed outside
of the USA, Canada, and Puerto Rico,
international rates will apply and may
differ based on landline or mobile phone).

▼

Gate operator/Canadian
Programming

Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission ―
which may not be long enough for
HomeLink to pick up the signal during
programming. Similar to this Canadian
law, some U.S. gate operators are designed
to “time-out” in the same manner.
 
If you live in Canada or are having
difficulties programming a gate operator
by using the programming procedures
(regardless of where you live), 

replace

Step 3 of Programming the HomeLink
System

 with the following:

When Driving

Switches and Controls

4-90

CX-5_8HE3-EA-18I_Edition1

2018-6-29 13:44:47