Owner Maintenance; Maintenance and Care- Page 572

6. Turn the socket and bulb assembly

counterclockwise and remove it.
 

7. Temporarily install the light unit with

the socket pulled out of the top of the
light unit.
 

Socket pull-out range

CAUTION



The wiring harness may be damaged
when temporarily installing the light
unit. When performing the
procedure, observe the following
points.



Pull out the socket from within the
socket pull-out range shown in the
figure.



Do not push the light unit into the
vehicle with force.



When temporarily installing the light
unit, cover the rear bumper light unit
installation surface with a soft cloth.
The rear bumper may be scratched or
damaged if the light unit contacts it.

8. Disconnect the bulb from the socket.

9. Install the new bulb in the reverse

order of the removal procedure.

Reverse lights

1. Make sure the ignition is switched off,

and the headlight switch is off.

2. Remove the cover.

3. Disconnect the electrical connector

from the bulb by pressing the tab on

Maintenance and Care

Owner Maintenance

6-42

CX-9_8JK1-EA-20G_Edition2_old

2020-7-20 17:31:45