Essential Safety Equipment; for a child-restraint system:; the head restraint and the seatback:- Page 49

2–37

Essential Safety Equipment

Child-Restraint

    Installation  on  rear  outboard  seats

     1.   First,  adjust  the  front  seat  to  allow 

clearance between the child-restraint 
system and the front seat (page  2-5 ).

   2.   Make sure the seatback is securely 

latched by pushing it back until it is 
fully locked.

   3.   Expand the area between the seat 

bottom and the seatback slightly to 
verify the locations of the LATCH 
lower anchors.

   NOTE

  The markings above the LATCH lower 
anchors indicate the locations of the 
LATCH lower anchors for the attachment 
of a child-restraint system.

   4.   Raise the head restraint to the top 

locked position. 

Refer to Head Restraints on page  2-10  .

 5.   Secure the child-restraint system 

using BOTH LATCH lower anchors, 
following the child-restraint system 
manufacturer's instruction. Pull on the 
child-restraint to be sure both anchors 
are engaged.

   6.   If  your  child-restraint  system  came 

equipped with a tether, that means it is 
very important to properly secure the 
tether for child safety. Please carefully 
follow the child-restraint system 
manufacturer's instructions when 
installing tethers.

WARNING

  Use the tether and tether anchor only 
for a child-restraint system:

  Using the tether or tether anchor to 
secure anything but a child-restraint 
system is dangerous. This could 
weaken or damage the tether or tether 
anchor and result in injury.
  

  Always route the tether strap between 
the head restraint and the seatback:

  Routing the tether strap on top of 
the head restraint is dangerous. In a 
collision the tether strap could slide off  
the head restraint and loosen the child-
restraint system. The child-restraint 
system could move which may result in 
death or injury to the child.

Anchor bracket

Tether strap

(4-Door)

/C\FCA&('#*A'FKVKQPKPFD

/C\FCA&('#*A'FKVKQPKPFD