When Driving; Switches and Controls; rapidly for - Page 186

4–60

When Driving

Switches and Controls

   NOTE

  Some gate operators and garage door 
openers may require you to replace this 
Programming Step 2 with procedures 
noted in the “Gate Operator/Canadian 
Programming” section.

   4.   After  the  HomeLink  indicator  light 

changes from a slow to a rapidly 
blinking light, release both the 
HomeLink and hand-held transmitter 
buttons.

   NOTE

  If the HomeLink indicator light does not 
change to a rapidly blinking light, contact 
HomeLink at 

 www.homelink.com

  or call 

1-800-355-3515

  for assistance.

   5.   Connect power to the device being 

programmed.

   6.   Firmly press and hold the programmed 

HomeLink button for fi ve seconds, 
and then release it. Perform this 
operation two times to activate the door 
or gate. If the door or gate does not 
activate, press and hold the just-trained 
HomeLink button and observe the 
indicator light.

If the indicator light stays on 
constantly, programming is complete 
and your device should activate when 
the HomeLink button is pressed and 
released.

   NOTE

  To program the remaining two HomeLink 
buttons, begin with “Programming”

 — 

step 1

  If the indicator light blinks  

rapidly for 

two seconds and then turns to a constant 
light, continue with “Programming” 
steps 7—9

  to complete the programming 

of a rolling code equipped device (most 
commonly a garage door opener).
   7.   At the garage door opener receiver 

(motor-head unit) in the garage, locate 
the “learn” or “smart” button. This can 
usually be found where the hanging 
antenna wire is attached to the motor-
head unit.

   8.   Firmly press and release the “learn” or 

“smart” button. (The name and color of 
the button may vary by manufacturer.) 

   NOTE

  Complete the programming within 30 
seconds.

   9.   Return  to  the  vehicle  and  fi rmly  

press, 

hold for two seconds and release

   the 

programmed HomeLink button. Repeat 
the “ 

press/hold/release

 ” sequence a 

second time, and, depending on the 
brand of the garage door opener (or 
other rolling code equipped device), 
repeat this sequence a third time to 
complete the programming process.

  HomeLink should now activate your 
rolling code equipped device.

   NOTE

  To program the remaining two HomeLink 
buttons, begin with “Programming” 

—

step 1

  For questions or comments, please contact 
HomeLink at

www.homelink.com

  or  

1-

800-355-3515

 .