Owner Maintenance; Maintenance and Care; Rear turn signal lights, Brake lights/- Page 467

6–55

Maintenance and Care

Owner Maintenance

7.  Disconnect the bulb by pulling it out.

Rear turn signal lights, Brake lights/

Taillights/Rear side-marker lights 

(Bulb type)

8.  Install the new bulb.

9.  Insert the wing bolt into the jack with 

the jack screw pointing to the down 

and turn the wing bolt clockwise to 

temporarily tighten it.

10. Turn the jack screw in the direction 

shown in the figure.

11. Turn the wing bolt completely to secure 

the jack.

NOTE

If the jack is not completely secured, it 

could rattle while driving. Make sure the 

jack screw is sufficiently tightened.

12. Install the cover in the reverse order of 

the removal procedure.

13. Insert the cover tabs and install the 

cover.

Tabs

NOTE

Verify that the cover is securely installed.

Reverse lights

4–Door

1.  Make sure the ignition is switched off, 

and the headlight switch is off.

2.  Pull the center of each plastic retainer 

and remove the retainers.

3.  Peel back the trunk lid trim.

Removal

Installation

Mazda3_8FL6-EA-16F_Edition2.indb   55

2016/08/10   17:38:56