Passenger Occupant Classification; Essential Safety Equipment; Do not allow a child or anyone to lean over- Page 51

Do not allow a child or anyone to lean over
or against the side window of a vehicle
with side and curtain air bags:

It is dangerous to allow anyone to lean over
or against the side window, the area of the
front passenger seat, the front and rear
window pillars and the roof edge along
both sides from which the side and curtain
air bags deploy, even if a child-restraint
system is used. The impact of inflation from
a side or curtain air bag could cause serious
injury or death to an out of position child.
Furthermore, leaning over or against the
front door could block the side and curtain
air bags and eliminate the advantages of
supplemental protection. With the front air
bag and the additional side air bag that
comes out of the front seat, the rear seat is
always a better location for children. Take
special care not to allow a child to lean
over or against the side window, even if the
child is seated in a child-restraint system.

Always remove the head restraint and
install child-restraint system (except when
installing a backless booster seat):

Installing a child-restraint system without
removing the head restraint is dangerous.
The child-restraint system cannot be
installed correctly which may result in
death or injury to the child in a collision.

Always install the head restraint and adjust
it to the appropriate position after
removing the child-restraint system:

Driving with the head restraint removed is
dangerous as impact to the occupant's
head cannot be prevented during
emergency braking or in a collision, which
could result in a serious accident, injury or
death.
Refer to Head Restraints on page 2-10.

Front Passenger's Seat Child-Restraint
System Installation (With Front
Passenger Occupant Classification
System)

1. Make sure the ignition is switched off.
2. Slide the seat as far back as possible.

3. Remove the head restraint. However,

when installing a backless booster seat,
always install the vehicle head restraint
to the seat where the backless booster
seat is installed.

4. Place the child-restraint system on the

seat without putting your weight on the
seat and fasten the seat belt. See the
manufacturer's instructions on the
child-restraint system for belt routing
instructions.

5. To get the retractor into the automatic

locking mode, pull the shoulder belt
portion of the seat belt until the entire
length of the belt is out of the retractor.

6. Push the child-restraint system firmly

into the vehicle seat. Be sure the belt
retracts as snugly as possible. A
clicking noise from the retractor will
be heard during retraction if the system
is in automatic locking mode. If the
belt does not lock the seat down tight,
repeat the previous step and also this
one.

Essential Safety Equipment

Child-Restraint

2-37

Mazda3_8GE4-EA-17F_Edition1

2017-4-7 11:59:21