Interior Features; recognition rate and voice quality, the ; following points should be observed:- Page 292

5–86

Interior Features

Bluetooth

®

  Commands useable anytime during 
voice recognition

    “Help” or “Go Back” are commands 
which can be used at anytime during voice 
recognition.

  Help  function  use

    The help function informs the user of all 
the available voice commands under the 
current conditions.

   1.    

Say:

  [Beep] “Help”

   2.   Follow the prompts to receive the 

appropriate voice guidance instructions.

  Returning to previous operation

    This command is for returning to the 
previous operation while in the voice 
recognition mode.

Say:

  [Beep] “Go Back”

  To prevent a deterioration in the voice 
recognition rate and voice quality, the 
following points should be observed:

y

 The hands-free system cannot perform 

voice recognition while voice guidance 
or a beep sound is operating. Wait until 
the voice guidance or the beep sound is 
fi nished before saying your commands.

y

 Dialects or different wording other 

than hands-free prompts cannot be 
recognized by voice recognition. Speak 
in the wording specifi ed by the voice 
commands.

y

 It is not necessary to face the 

microphone or approach it. Speak the 
voice commands while maintaining a 
safe driving position.

y

 Do not speak too slow or too loud.

y

 Speak clearly, without pausing between 

words or numbers.

y

 Close the windows and/or the moonroof 

to reduce loud noises from outside 
the vehicle, or turn down the airfl ow 
of the air-conditioning system while 
Bluetooth

®

  Hands-Free is being used.

y

 Make sure the vents are not directing air 

up towards the microphone.

   NOTE

  If the voice recognition performance is not 
satisfactory.
  Refer to Voice Recognition Learning 
Function (Speaker Enrollment) (Type A) 
on  page   5-88 .
  Refer to Troubleshooting on page  5-126 .

 Security Setting (Type A)

    If a passcode is set, the system cannot be 
activated unless the passcode is input.

   NOTE

  Do this function only when parked. It is 
too distracting to attempt while driving 
and you may make too many errors to be 
effective.

  Passcode  setting

     1.   Press  the  pick-up  button  or  talk  button 

with a short press.

   2.    

Say:

  [Beep] “Setup”

   3.    

Prompt:

  “Select one of the following: 

Pairing options, confi rmation prompts, 
language, passcode, select phone or 
select music player.”

   4.    

Say:

  [Beep] “Passcode”

   5.    

Prompt:

  “Passcode is disabled. Would 

you like to enable it?”

   6.    

Say:

  [Beep] “Yes”

   7.    

Prompt:

  “Please say a 4-digit 

passcode. Remember this passcode. It 
will be required to use this system.”

   8.    

Say:

  [Beep] “XXXX” (Say a desired 

4-digit passcode, “PCode”.)