Interior Features; Function (Speaker Enrollment) ; for the fi rst time- Page 294

5–88

Interior Features

Bluetooth

®

 Voice Recognition Learning 

Function (Speaker Enrollment) 
(Type A)

    The  voice  recognition  learning  function 
enables voice recognition appropriate to 
the characteristics of the user's voice. If the 
recognition of the voice input commands 
to the system is not adequate, this function 
can largely improve the system's voice 
recognition of the user. If your voice can 
be recognized suffi ciently without using 
this function, you may not realize the 
added benefi t of the function. To register 
your voice, the voice input command 
list must be read out. Read out the list 
when the vehicle is parked. Perform the 
registration in as quiet a place as possible 
 5-85 . The registration must be performed 
completely. The required time is a few 
minutes. The user needs to be seated in the 
driver's seat with the voice input command 
list for voice recognition learning open to 
the page indicated below.

  When voice recognition learning is done 
for the fi rst time

     1.   Press  the  pick-up  button  or  talk  button 

with a short press.

   2.    

Say:

  [Beep] “Voice training”

   3.    

Prompt:

  “This operation must be 

performed in a quiet environment while 
the vehicle is stopped. See the owner's 
manual for the list of required training 
phrases. Press and release the talk 
button when you are ready to begin. 
Press the hang-up button to cancel at 
any time.”

   4.   Press the talk button with a short press.
   5.   The voice guidance reads out the voice 

input command number (refer to the 
voice input command list for voice 
recognition learning). (Ex. “Please read 
phrase  1” ) 

 6.    

Say:

  [Beep] “0123456789” (Say 

the voice input command for voice 
recognition learning (1 to 8) according 
to the voice guidance.)

   7.    

Prompt:

  “Speaker enrollment is 

complete.”

   NOTE

  If an error occurred in the voice 
recognition learning, re-learning can be 
done by pressing the talk button with a 
short press.

  Voice  recognition  re-learning

    If voice recognition learning has already 
been done.

   1.   Press the pick-up button or talk button 

with a short press.

   2.    

Say:

  [Beep] “Voice training”

   3.    

Prompt:

  “Enrollment is enabled/

disabled. Would you like to disable/
enable or retrain?”

   4.    

Say:

  [Beep] “Retrain”

   5.    

Prompt:

  “This operation must be 

performed in a quiet environment while 
the vehicle is stopped. See the owner's 
manual for the list of required training 
phrases. Press and release the talk 
button when you are ready to begin. 
Press the hang-up button to cancel at 
any time.”

   6.   Press the talk button with a short press.
   7.   The voice guidance reads out the voice 

input command number (refer to the 
voice input command list for voice 
recognition learning). (Ex. “Please read 
phrase 1”)

   8.    

Say:

  [Beep] “0123456789” (Say 

the voice input command for voice 
recognition learning (1 to 8) according 
to the voice guidance.)

   9.    

Prompt:

  “Speaker enrollment is 

complete.”