Brake Warning Light; Master Warning Light; Low Fuel Level- Page 37

36

1

 •   Rotate the knob to adjust the brightness  

of the instrument cluster and other  

dashboard illuminations.

2

 •  Push to toggle between trip meter (A & B).

•  When a trip meter is selected, push and 

hold to reset to zero.

3

 •   Push the knob for 1.5 seconds or more to 

change the speed units between km/h and mph.

Brake Warning Light

Parking brake on/low brake  
fluid/malfunction

Master Warning Light

Low Fuel Level

Low Engine Oil Pressure

Power Steering Malfunction

Automatic Transaxle  

Warning Light

Charging System 

Malfunction

Door/Trunk/Tailgate Ajar

Low Washer Fluid Level 

Warning Light

KEY Warning Light 

RED

KEY Indicator Light 

GREEN

Check Fuel Cap

 Perform  Maintenance

  i-ELOOP  Status

 (p. 34 ) 

On

: Power generation  

Flashing

: Pre-Charge Mode

DASHBOARD ILLUMINATION/ 

DIMMER

1

/

TRIP METER

2

www.MazdaUSA.com

ENGINE COOLANT TEMP LIGHTS 

Since this vehicle does not use an engine 

coolant temperature gauge, red and blue 

engine coolant temperature lights are used to 

indicate high and low coolant temperature.

Red Coolant Temp Light

Flashing:

 Engine is starting to run hot. 

Drive slowly to reduce engine load. 

On:

 Engine is overheating. Safely pull 

over to the side of the road and turn the 

engine off. Refer to the Owner’s Manual 

for more information.

Blue Coolant Temp Light

On:

 Engine coolant is cold and no warm 

air is available for heater/defroster. 

Off:

 Engine coolant is warm and warm air 

is available for heater/defroster. The light 

may stay on for a few minutes after start-

up when the engine is cold, but the vehicle 

can be driven with the light on or off.

TRIP COMPUTER 

The following information 

can be selected by pushing 

the   or   of the INFO 

button on the steering wheel.

•   Approximate  distance 

you can travel on the 

available fuel (RANGE)

•  Average fuel economy
 

•  Current fuel economy
 

•  Average vehicle speed
 

•  To reset, push and hold

the INFO button for

more than 1.5 seconds.