Owner Maintenance; Maintenance and Care; Rear turn signal lights- Page 461

6–57

Maintenance and Care

Owner Maintenance

6.  Disconnect the connector from the unit 

by pressing the tab on the connector 

with your finger and pulling the 

connector.

Rear turn signal lights

Brake lights/Taillights/Rear side-

marker lights (Bulb type)

7.  Disconnect the bulb by pulling it out.

Rear turn signal lights, Brake lights/

Taillights/Rear side-marker lights 

(Bulb type)

8.  Install the new bulb.

9.  Insert the wing bolt into the jack with 

the jack screw pointing to the down 

and turn the wing bolt clockwise to 

temporarily tighten it.

10. Turn the jack screw in the direction 

shown in the figure.

11. Turn the wing bolt completely to secure 

the jack.

NOTE

If the jack is not completely secured, it 

could rattle while driving. Make sure the 

jack screw is sufficiently tightened.

Mazda3_8FA4-EA-15G_Edition1.indb   57

2015/05/11   14:02:26