Authorized Mazda Dealer.- Page 139

2010 Mazda MAZDA5 Owners Manual

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

9. Customer Information
background image

Black plate (139,1)

When changing tires yourself

If you or someone else changes tires, you
or someone else can also undertake the
steps for the TPMS to complete the ID
signal code registration.

1. After tires have been changed, turn the

ignition switch to the ON position, then
turn it back to the ACC or LOCK
position.

2. Wait for about 15 minutes.

3. After about 15 minutes, drive the

vehicle at a speed of at least 25 km/h
(16 mph) for 10 minutes and the tire
pressure sensor ID signal code will be
registered automatically.

NOTE

If the vehicle is driven within about 15 minutes
of changing tires, the tire pressure monitoring
system warning light will flash because the
sensor ID signal code would not have been
registered. If this happens, park the vehicle for
about 15 minutes, after which the sensor ID
signal code will register upon driving the
vehicle for 10 minutes.

Replacing tires and wheels

CAUTION

Ø

When replacing/repairing the tires
or wheels or both, have the work
done by an Authorized Mazda
Dealer, or the tire pressure sensors
may be damaged.

Ø

The wheels equipped on your
Mazda are specially designed for
installation of the tire pressure
sensors. Do not use non-genuine
wheels, otherwise it may not be
possible to install the tire pressure
sensors.

Be sure to have the tire pressure sensors
installed whenever tires or wheels are
replaced.
When having a tire or wheel or both
replaced, the following types of tire
pressure sensor installations are possible.

l

The tire pressure sensor is removed
from the old wheel and installed to the
new one.

l

The same tire pressure sensor is used
with the same wheel. Only the tire is
replaced.

l

A new tire pressure sensor is installed
to a new wheel.

NOTE

l

The tire pressure sensor ID signal code
must be registered when a new tire pressure
sensor is purchased. For purchase of a tire
pressure sensor and registration of the tire
pressure sensor ID signal code, consult an
Authorized Mazda Dealer.

l

When reinstalling a previously removed tire
pressure sensor to a wheel, replace the
grommet (seal between valve body/sensor
and wheel) for the tire pressure sensor.

Driving Your Mazda

Starting and Driving

5-31

Mazda5_8AU7-EA-09H_Edition4 Page139
Tuesday, March 30 2010 1:10 PM

Form No.8AU7-EA-09H

Detailed Information for 2010 Mazda MAZDA5 Owners Manual

Lists of information found in 2010 Mazda MAZDA5 Owners Manual - Page 139

  • 1. After tires have been changed, turn the ignition switch to the ON position, then turn it back to the ACC or LOCK position.
  • 2. Wait for about 15 minutes.
  • 3. After about 15 minutes, drive the vehicle at a speed of at least 25 km/h (16 mph) for 10 minutes and the tire pressure sensor ID signal code will be registered automatically.