Wireless ; Control System*; Always check the Owner’s Manual for more operating information and safety features - Page 10

H O M E L I N K

®

Always check the Owner’s Manual for more operating information and safety features 

HomeLink

®

Driving

Tips

Auto-dimming rear 
view mirror*

Auto-dimming function changes
are based on outside lighting 
conditions and if bright headlights
are visible in rear view mirror
Press on (

2

), off (

3

)

ABS self test

A self-diagnostic test is performed
when starting; you may feel some
brake pedal pulsation and hear
some noise, this is normal

Traction Control System (TCS)

Enhances traction and safety by 
regulating engine torque 
When TCS detects drive wheel 
slippage it lowers engine torque 
to prevent loss of traction

Rolling code synchronization
procedure

Refer to your garage door opener or
device instruction manual to confirm
your system is equipped with a
rolling code feature

Tip: This procedure is easier 
to perform with the assistance
of another person

To synchronize: Press programming
button on garage door opener
motor; press/hold for 2 seconds
and release the programmed
HomeLink

®

button 2 times 

within 30 seconds of pressing 
the garage door opening 
motor programming button
Some devices may require you 
to press/hold and release a 
third time to complete 
programming procedure
If indicator light stays on, 
programming is complete

To erase all existing programming;
press and hold two outer 
HomeLink

®

buttons (

1

) on mirror, 

continue to hold buttons until 
indicator light flashes

Anti-lock Braking System (ABS)

ABS automatically reduces
hydraulic pressure to any wheel
on the verge of locking up
You may feel a slight pulsing of
the brake pedal and hear a 
clicking noise; this tells you the
ABS is functioning properly;
increase pressure on pedal for
maximum braking 

Tips: Maintain constant 
pressure on the brake pedal
Do not pump the brakes

To program or reprogram: 
Press and hold two outer
HomeLink

®

buttons (

1

) for 20 

seconds and no more than 
30 seconds, release only after 
indicator light (

4

) begins to 

flash; hold transmitter for the
device to be programmed
between 1-3 inches to 
HomeLink

®

; press transmitter 

button and desired HomeLink

®

button (

1

) simultaneously until

HomeLink

®

indicator light (

4

)

goes from slow to rapid flashing
Verify device operation by 
pressing HomeLink

®

button (

1

)

that was just programmed

Tip: You do not need to repeat
the first step to program the
other two hand-held transmit-
ters for the remaining
HomeLink® buttons

For further information, contact
HomeLink

®

at 

1

-

8

00-355-35

1

5,

www.homelink.com

or your

authorized Mazda Dealer

Gas cap

After filling vehicle with gasoline,
fully reinstall gas cap by turning
clockwise until a clicking sound is
heard, if gas cap is not fully
installed, Check Engine light 
may come on
For more information on Check
Engine light, see Owner’s Manual

HomeLink

®

Wireless 

Control System*

Located on rear view mirror
HomeLink

®

provides three 

programmable buttons that 
will replace three hand-held 
device transmitters

Tip: It is recommended to 
park outside of garage when 
programming HomeLink

®

WARNING: When programming 
a garage door or gate opener,
disconnect power to these
devices before programming,
continuous operation of these
devices could damage the motor

*Denotes optional equipment

1

1

4

2 3