Wireless ; Control System*; Always check the Owner’s Manual for more operating information and safety features - Page 10

H O M E L I N K

®

Always check the Owner’s Manual for more operating information and safety features 

HomeLink

®

Interior 

Lights

Auto-dimming rear 
view mirror*

Auto-dimming function changes
are based on outside lighting 
conditions and if bright headlights
are visible in rear view mirror.
Press on (

2

), off (

3

).

5. Moonroof tilt switch

Press rear of switch to 
tilt rear of moonroof.
Press front of switch to close.

6. Moonroof slide switch

Press rear of switch to open
moonroof.
Press front of switch to close.

Illuminated visor mirrors

Mirrors lighted when covers 
open; off when closed.

Rolling code synchronization
procedure

Refer to your garage door opener or
device instruction manual to confirm
your system is equipped with a
rolling code feature.

Tip: This procedure is easier 
to perform with the assistance
of another person.

To synchronize: Press programming
button on garage door opener
motor; press/hold for 2 seconds
and release the programmed
HomeLink

®

button 2 times 

within 30 seconds of pressing 
the garage door opening 
motor programming button.
Some devices may require you 
to press/hold and release a 
third time to complete 
programming procedure.
If indicator light stays on, 
programming is complete.

To erase all existing programming;
press and hold two outer
HomeLink

®

buttons (

1

) on mirror, 

continue to hold buttons until 
indicator light flashes.

1. Map/reading light switch

Press on/off.

2. Interior light switch

DOOR = light on when 
door open
OFF = light always off

3. Interior map/reading

light

4. Sunglass holder

Press concaved lip to open.

To program or reprogram: 
Press and hold two outer
HomeLink

®

buttons (

1

) for 20 

seconds and no more than 
30 seconds, release only after 
indicator light (

4

) begins to 

flash; hold transmitter for the
device to be programmed
between 1-3 inches to 
HomeLink

®

; press transmitter 

button and desired HomeLink

®

button (

1

) simultaneously until

HomeLink

®

indicator light (

4

)

goes from slow to rapid flashing.
Verify device operation by 
pressing HomeLink

®

button (

1

)

that was just programmed.

Tip: You do not need to 
repeat the first step to program
the other two hand-held 
transmitters for the remaining
HomeLink

®

buttons.

For further information, contact
HomeLink

®

at 

1

-

8

00-355-35

1

5,

www.homelink.com

or your

authorized Mazda Dealer.

HomeLink

®

Wireless 

Control System*

Located on rear view mirror.
HomeLink

®

provides three 

programmable buttons that 
will replace three hand-held 
device transmitters.

Tip: It is recommended to 
park outside of garage when 
programming HomeLink

®

.

WARNING: When programming 
a garage door or gate opener,
disconnect power to these
devices before programming,
continuous operation of these
devices could damage the motor.

*Denotes optional equipment

1

1

4

2 3

TILT

SLIDE

1

2

1

4

3

3

5

6

OFF

DOO

R