Driving Your Mazda- Page 193

2006 Mazda RX-8 Owners Manual

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

9. Customer Information and Reporting Safety Defects
background image

Black plate (193,1)

q

Programming the HomeLink System

CAUTION

When programming a garage door
opener or a gate, disconnect the power
to these devices before performing
programming, as continuous operation
of the devices could damage the motor.

The HomeLink system provides 3 buttons
which can be individually selected and
programmed using the transmitters for
current, on-market devices as follows:

1. Press and hold the two outer

HomeLink buttons (buttons one and
three)

releasing only when the

indicator light begins to flash (after 20
seconds).

Do not

hold the buttons for

longer than 30 seconds and

do not

repeat step 1

to program a second and/

or third hand-held transmitter to the
remaining two HomeLink buttons.

2. Position the end of your hand-held

transmitter 2.5

7.5 cm (1

3 inches)

away from the HomeLink button you
wish to program while keeping the
indicator light in view.

3. Simultaneously press and hold both the

chosen HomeLink and hand-held
transmitter buttons.

Do not release the

buttons until step 4 has been
completed.

NOTE

Some gate operators and garage door
openers may require you to replace this
Programming Step 3 with procedures
noted in the

Gate Operator/Canadian

Programming

section.

4. After the HomeLink indicator light

changes from a slow to a rapidly
blinking light, release both the
HomeLink and hand-held transmitter
buttons.

NOTE

If the HomeLink indicator light does
not change to a rapidly blinking light,
contact HomeLink at

www.homelink.com

or call

1-800-355-

3515

for assistance.

5. Press and hold the just-trained

HomeLink button and observe the
indicator light.

If the indicator light

stays on constantly,

programming is complete

and your

device should activate when the
HomeLink button is pressed and released.

NOTE

To program the remaining two
HomeLink buttons, begin with

Programming

step 2. Do not

repeat step 1.

If the indicator light blinks

rapidly for

two seconds and then turns to a
constant light, continue with

Programming

steps 6

8

to complete

the programming of a rolling code
equipped device (most commonly a
garage door opener).

6. At the garage door opener receiver

(motor-head unit) in the garage, locate
the

learn

or

smart

button. This can

usually be found where the hanging
antenna wire is attached to the motor-
head unit.

Driving Your Mazda

Switches and Controls

5-63

RX-8_8U58-EA-05J_Edition1 Page193
Thursday, August 25 2005 4:56 PM

Form No.8U58-EA-05J

Detailed Information for 2006 Mazda RX-8 Owners Manual

Lists of information found in 2006 Mazda RX-8 Owners Manual - Page 193

  • 1. Press and hold the two outer HomeLink buttons (buttons one and three) ― releasing only when the indicator light begins to flash (after 20 seconds).
  • 2. Position the end of your hand-held transmitter 2.
  • 7.5 cm (1 ― 3 inches) away from the HomeLink button you wish to program while keeping the indicator light in view.
  • 3. Simultaneously press and hold both the chosen HomeLink and hand-held transmitter buttons.
  • 4. After the HomeLink indicator light changes from a slow to a rapidly blinking light, release both the HomeLink and hand-held transmitter buttons.
  • 5. Press and hold the just-trained HomeLink button and observe the indicator light.
  • 2. Do not repeat step 1.
  • 6. At the garage door opener receiver (motor-head unit) in the garage, locate the “ learn ” or “ smart ” button.