Auto lock function operation stop beeper- Page 163

uu

Locking and Unlocking the Doors

u

Locking/Unlocking the Doors from the Outside

162

Co
ntrols

To temporarily deactivate the function:

1.

Set the power mode to OFF.

2.

Open the driver’s door.

3.

Using the master door lock switch, operate 
the lock as follows:
Lock



Unlock



Lock



Unlock.

u

The beeper sounds and the function is 
deactivated.

To restore the function:

•

Set the power mode to ON.

•

Lock the vehicle without using the auto lock 
function.

•

With the keyless remote on you, move out 
of the auto lock function operation range.

•

Open any door.

1

Locking the doors and tailgate (Walk away auto lock

®

)

The auto lock function does not operate when any of 
the following conditions are met.

•

The keyless remote is inside the vehicle.

•

A door, tailgate or the hood is not closed.

•

The power mode is set to any mode other than 
OFF.

•

The keyless remote is not located within a radius of 
about 5 feet (1.5 m) from the vehicle when you get 
out of the vehicle and close the doors and tailgate.

Auto lock function operation stop beeper

After the auto lock function has been activated, the 
auto lock operation stop beeper sounds for 
approximately two seconds in the following cases.

•

The keyless remote is put inside the vehicle through 
a window.

•

You are located too close to the vehicle.

•

The keyless remote is put inside the tailgate.

If the warning beeper sounds, check that you are 
carrying the keyless remote. Then, open/close a door 
and confirm the auto lock activation beeper sounds 
once.

If equipped, the user must wait until the power 
tailgate fully closes before the auto lock function will 
be activated.

Models with power tailgate

22 US ODYSSEY-31THR6400.book  162 ページ  ２０２０年１１月１６日　月曜日　午後１時４１分