Some Driver Assist Systems Cannot ; Operate: Camera Temperature Too High; Operate: Clean Front Windshield- Page 210

209

uu

Operating the Switches Around the Steering Wheel

u

Auto High-Beam

Co
ntrols

You can turn the auto high-beam system off. If you want to turn the system off or 
on, set the power mode to ON, then carry out the following procedures while the 
vehicle is stationary.

To turn the system off:

With the light switch is in 

AUTO

, pull the lever 

toward you and hold it for at least 40 seconds.
After the auto high-beam indicator light blinks 
twice, release the lever.

To turn the system on:

With the light switch is in 

AUTO

, pull the lever 

toward you and hold it for at least 30 seconds.
After the auto high-beam indicator light blinks 
once, release the lever.

■

How to Turn Off the Auto High-Beam

1

How to Use the Auto High-Beam

If the 

Some Driver Assist Systems Cannot 

Operate: Camera Temperature Too High

 message 

appears:

•

Use the climate control system to cool down the 
interior and, if necessary, also use defroster mode 
with the airflow directed toward the camera.

•

Start driving the vehicle to lower the windshield 
temperature, which cools down the area around 
the camera.

If the 

Some Driver Assist Systems Cannot 

Operate: Clean Front Windshield

 message 

appears:

•

Park your vehicle in a safe place, and clean the 
windshield. If the message does not disappear after 
you have cleaned the windshield and driven for a 
while, have your vehicle checked by a dealer.

1

How to Turn Off the Auto High-Beam

If you turn the auto high-beam system off, the system 
does not operate until you turn the system on.

Park in a safe place before turning the system off or 
on.

AUTO

 Position

22 US ODYSSEY-31THR6400.book  209 ページ  ２０２０年１１月１６日　月曜日　午後１時４１分