How to Set Up the Jack- Page 727

uu

If a Tire Goes Flat

u

Changing a Flat Tire

726

Han

d

lin
g the U

n

expected

1.

Place the jack under the jacking point 
closest to the tire to be changed.

2.

Turn the end bracket clockwise as shown in 
the image until the top of the jack contacts 
the jacking point.

u

Make sure that the jacking point tab is 
resting in the jack notch.

3.

Raise the vehicle, using the jack handle bar 
and the jack handle, until the tire is off the 
ground.

■

How to Set Up the Jack

1

How to Set Up the Jack

Do not use the jack with people or luggage in the 
vehicle.

Use the jack provided in your vehicle.
Other jacks may not support the weight (“load”) or 
may not fit the jacking point.

The following instructions must be followed to use 
the jack safely:

•

Do not use while the engine is running.

•

Use only where the ground is firm and level.

•

Use only at the jacking points.

•

Do not get in the vehicle while using the jack.

•

Do not put anything on top of or underneath the 
jack.

Turn off the sliding door main switch before 
replacing a rear tire. If the main switch is on, the 
power sliding door may accidentally operate, causing 
an accident.

3

WARNING

The vehicle can easily roll off the jack, 
seriously injuring anyone underneath.

Follow the directions for changing a tire 
exactly, and never get under the vehicle 
when it is supported only by the jack.

Models with power sliding doors

Jack 
Handle 
Bar

Wheel Nut

 Wrench as Jack Handle

22 US ODYSSEY-31THR6400.book  726 ページ  ２０２０年１１月１６日　月曜日　午後１時４１分