Remote Vehicle Start; Express Power Windows; Note: - Page 4

4

Remote Vehicle Start

F

A fuel-saving stop/start system has been integrated with the 1.4L turbocharged engine. 

While driving, when the brakes are applied and the vehicle is at a complete stop, the 

engine may turn off, depending on conditions. When the engine stops, the tachometer 

gauge will read AUTO STOP. The audio  system, climate controls and other accessories will 

continue to operate. Upon releasing the brake pedal or applying the accelerator pedal, the 

engine will restart. After turning off the engine, the tachometer gauge will read OFF. 
The engine may remain running or restart if:
•  A minimum vehicle speed is not reached.
•  The shift lever is in any gear other than Drive (D).
•  The battery state of charge is low.
•  The outside temperature is not in the required operating range.
•  The engine or transmission is not at the required operating temperature.
•  The climate control system requires the engine to run based on the climate control or 

defog setting. Select the ECO air conditioning setting (green A/C indicator) to maximize 

the frequency and duration of Auto Stops. 

•  The Auto Stop time is greater than two minutes.

See Driving and Operating in your Owner Manual. 

  With the vehicle parked, push down the lever on the left side of the steering column to 

adjust the steering wheel. The steering wheel can then be moved up or down and in or 

out. Pull up the lever to lock the steering wheel in place.

See Instruments and Controls in your Owner Manual.

  All windows have an express-down feature. Fully press the desired window switch for 

the window to open completely.

  The driver’s window has an express-up feature. Fully pull the driver’s window switch 

for the window to close completely.

See Keys, Doors and Windows in your Owner Manual.

F

Optional equipment

Engine Stop/Start Operation

F

Tilt/Telescope Steering Wheel

Express Power Windows

Use Remote Vehicle Start to start the engine from outside the vehicle. During a remote 

start, the engine will run for 10 minutes.

  Press and release the   

Lock

 button and then press and hold the

 Remote Start

button until the turn signal lamps flash. After entering the vehicle, turn the ignition to 

the On position.

  Press and hold the 

 button until the parking lamps turn off to cancel a remote start.

Note: 

To change the remote start settings, go to Remote Lock, Unlock, Start in the Vehicle Settings menu.

See Keys, Doors and Windows in your Owner Manual.