When Driving; two seconds and then turns to a; constant light, continue with- Page 254

NOTE

If the HomeLink indicator light does
not change to a rapidly blinking light,
contact HomeLink at

www.homelink.com

 or call

1-800-355-3515

 for assistance.

5. Connect the power to the garage door

opener or gate programmed to the
hand-held transmitter.

6. Firmly press and hold the programmed

HomeLink button for five seconds, and
then release it. Perform this operation
two times to activate the door or gate.
If the door or gate does not activate,
press and hold the just-trained
HomeLink button and observe the
indicator light.
If the indicator light stays on
constantly, programming is complete
and your device should activate when
the HomeLink button is pressed and
released.

NOTE

To program the remaining two
HomeLink buttons, begin with
“Programming”

―

 step 1

If the indicator light blinks 

rapidly for

two seconds and then turns to a
constant light, continue with
“Programming” steps 7―9

 to

complete the programming of a rolling
code equipped device (most commonly
a garage door opener).

7. At the garage door opener receiver

(motor-head unit) in the garage, locate
the “learn” or “smart” button. This can
usually be found where the hanging
antenna wire is attached to the
motor-head unit.

8. Firmly press and release the “learn” or

“smart” button. (The name and color

of the button may vary by
manufacturer.)

NOTE

Complete the programming within 30
seconds.

9. Return to the vehicle and firmly 

press,

hold for two seconds and release

 the

programmed HomeLink button. Repeat
the “

press/hold/release

” sequence a

second time, and, depending on the
brand of the garage door opener (or
other rolling code equipped device),
repeat this sequence a third time to
complete the programming process.

HomeLink should now activate your
rolling code equipped device.

NOTE

To program the remaining two HomeLink
buttons, begin with “Programming”

―

step 1

For questions or comments, please contact
HomeLink at 

www.homelink.com

 or

1-800-355-3515

.

▼

Gate operator/Canadian
Programming

Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission ―
which may not be long enough for
HomeLink to pick up the signal during
programming. Similar to this Canadian
law, some U.S. gate operators are designed
to “time-out” in the same manner.
 
If you live in Canada or you are having
difficulties programming a gate operator
by using the “Programming” procedures
(regardless of where you live), 

replace

When Driving

Switches and Controls

4-86

CX-9_8JK1-EA-20G_Edition2_old

2020-7-20 17:31:45