When Driving; Steering operation assist OFF- Page 332



The turn signal lever is operated.



The vehicle crosses a lane line.

NOTE



After the operation, the LAS & LDWS
operation may not operate for a period
of 5 seconds at the most until the lane
lines are detected.



Under the following conditions, the LAS
& LDWS cancels the warning/steering
assist automatically.



The driver takes his/her hands off the
steering wheel.
(The LAS & LDWS is designed to
assist the driver's steering operation
and it will resume operation
automatically when the driver holds
the steering wheel.)



The TCS OFF switch is pressed to
cancel the TCS.

Steering operation assist OFF
(non-operational)

The steering operation assist for the LAS
& LDWS can be changed to
non-operational (OFF).
Refer to the Settings section in the Mazda
Connect Owner's Manual.
When the steering operation assist has
been changed to inoperable (OFF), only
the lane departure warning is operational.

System operation

Make sure that the LAS & LDWS OFF
switch indicator light is turned off. When
the LAS & LDWS OFF switch indicator
light turns on, press the switch and make

sure that the switch indicator light turns
off.

Indicator light

Drive the vehicle in the center of the
driving lane while the LAS & LDWS OFF
switch indicator light is turned off.
The system becomes operational when all
of the following conditions are met.



The system detects white (yellow) lane
lines on both the right and left sides or
on either side.



The vehicle speed is about 60 km/h (37
mph) or faster.



The vehicle is driven on a straight road
or road with gentle curves.



The engine is running.

The LAS & LDWS goes on stand-by
status in the following cases:



The system cannot detect white (yellow)
lane lines.



The vehicle speed is less than about 60
km/h (37 mph).



The vehicle is making a sharp curve.



The vehicle is making a curve at an
inappropriate speed.

When Driving

i-ACTIVSENSE

4-164

CX-9_8JK1-EA-20G_Edition2_old

2020-7-20 17:31:45