Using Automatic Locking Mode; Essential Safety Equipment; Always install the head restraint and adjust- Page 47

Tether strap

Forward

(5-Door)

Tether strap

Forward

Always install the head restraint and adjust
it to the appropriate position after
removing the child-restraint system:

Driving with the head restraint removed is
dangerous as impact to the occupant's
head cannot be prevented during
emergency braking or in a collision, which
could result in a serious accident, injury or
death.
Refer to Head Restraints on page 2-10.

▼

Using Automatic Locking Mode

*

Follow these instructions when using a
child-restraint system, unless you are
attaching a LATCH-equipped
child-restraint system to the rear LATCH
lower anchors. Refer to “Using LATCH
Lower Anchor” (page 2-40).

NOTE

Follow the child-restraint system
manufacturer's instructions carefully. If
you are not sure whether you have a
LATCH system or tether, check in the
child-restraint system manufacturer's
instructions and follow them accordingly.
Depending on the type of child-restraint
system, it may use LATCH system instead
of seat belts or if the belt goes across the
child's chest, may recommend against
using automatic locking mode.

1. Make sure the seatback is securely

latched by pushing it back until it is
fully locked.

2. Remove the head restraint. However,

when installing a backless booster seat,
always install the vehicle head restraint
to the seat where the backless booster
seat is installed.
Refer to Head Restraints on page 2-10.

3. Secure the child-restraint system with

the lap portion of the lap/shoulder belt.
See the manufacturer's instructions on
the child-restraint system for belt
routing instructions.

Essential Safety Equipment

Child-Restraint

*Some models.

2-33

Mazda3_8GE4-EA-17F_Edition1

2017-4-7 11:59:21