Type A; Type B; Essential Safety Equipment- Page 61

Installation on rear outboard seats

1. First, adjust the front seat to allow

clearance between the child-restraint
system and the front seat.
Refer to Adjusting the Driver's Seat on
page 2-5.
Refer to Adjusting the Front
Passenger's Seat on page 2-13.

2. Make sure the seatback is securely

latched by pushing it back until it is
fully locked.

3. Remove the cover of the child-restraint

system's ISOFIX/LATCH

*1

 lower

anchors to verify the locations of the
ISOFIX/LATCH

*1

 lower anchors.

Lower anchor

Type A

Type B

NOTE



The ISOFIX/LATCH

*1

 lower

anchors marking on the cover
indicates the position of the ISOFIX/
LATCH

*1

 lower anchors for the

attachment of a child-restraint
system.



Store the removed cover so that it
does not get lost.

4. Remove the head restraint. However,

when installing a backless booster seat,
always install the vehicle head restraint
to the seat where the backless booster
seat is installed.
Refer to Head Restraints on page 2-17.

5. Secure the child-restraint system using

BOTH ISOFIX/LATCH

*1

 lower

anchors, following the child-restraint
system manufacturer's instruction. Pull
on the child-restraint to be sure both
anchors are engaged.

6. If your child-restraint system came

equipped with a tether, that means it is
very important to properly secure the
tether for child safety. Please carefully
follow the child-restraint system
manufacturer's instructions when
installing tethers.

*

1 ISOFIX (Mexico)/LATCH (Except

Mexico)

WARNING

Use the tether and tether anchor only for a
child-restraint system:

Using the tether or tether anchor to secure
anything but a child-restraint system is
dangerous. This could weaken or damage
the tether or tether anchor and result in
injury.

Essential Safety Equipment

Child Restraint

2-49

Mazda6_8HK6-EA-19A_Edition1

2018-11-15 9:36:06