When Driving; Switches and Controls; press and release - Page 154

4–50

When Driving

Switches and Controls

Continue to press and hold the HomeLink 

button while you 

press and release 

— every two seconds

 (“cycle”) your 

hand-held transmitter until the frequency 

signal has successfully been accepted by 

HomeLink. (The indicator light will flash 

slowly and then rapidly.)

Proceed with “Programming” step 4 to 

complete.

 Operating the HomeLink System

Press the programmed HomeLink button 

to operate a programmed device. The 

code will continue being transmitted for a 

maximum of 20 seconds.

 Reprogramming the HomeLink 

system

To program a device to HomeLink using 

a HomeLink button previously trained, 

follow these steps:
1.  Press and hold the desired HomeLink 

button. 

DO NOT

 release the button.

2.  The indicator light will begin to flash 

after 20 seconds. Without releasing 

the HomeLink button, proceed with 

“Programming” - step 1.

 Erasing Programmed HomeLink 

Buttons

To erase the existing programming from 

all three operating channels, press and 

hold the two outside buttons (

, 

) on 

the auto-dimming mirror until the 

HomeLink indicator light begins to flash 

after approximately 10 seconds.

Verify that the programming has been 

erased when you resell the vehicle.

MX-5_8EU4-EA-15D_Edition3.indb   50

2015/10/21   16:53:20