89
A
u
dio Operation
n
Band selection
Choose AM by pressing the
on-screen button and FM by pressing the
on-screen
button.
The selected mode will be indicated. If FM stereo is being received, STEREO will be
displayed.
n
Tuning
The radio has the following tuning methods: Manual, Seek, Scan, Preset channel, and Auto
memory tuning. The easiest way to tune stations is to set them on preset channels.
Note
l
If the FM broadcast signal becomes weak, reception automatically changes from STEREO
to MONO for reduced noise, and the STEREO indicator will go out.
l
Press the MAP button to switch to the map screen.
l
If the power supply is interrupted (fuse blows or the battery is disconnected), the preset
channels will be erased.
n
Manual tuning
Turning the TUNE dial will change the frequency higher or lower.
n
Seek tuning
Pressing and holding the SEEK/TRACK button (
,
) will cause the tuner to seek a
higher or lower frequency automatically.
Note
If you continue to press and hold the button, the frequency will continue changing without
stopping.
n
Scan tuning
Press the SCAN button to automatically sample strong stations.
Scanning stops at each station for about 5 seconds. To hold a station, press the SCAN
button again during this interval.
n
Preset channel tuning
The 8 preset channels can be used to store 8 AM and 16 FM stations.
1.To set a channel first select AM, FM1, or FM2. Tune to the desired station.
2.Press the TUNE dial.
3.Select any channel preset on-screen button for about 2 seconds until a beep sound is
heard. The selected preset channel number and station frequency will be displayed. The
station is now held in the memory.
4.Repeat this operation for the other stations and bands you want to store. To tune one in the
memory, select AM, FM1, or FM2 and then press its channel preset button. The station
frequency and the channel number will be displayed.
Note
If the power supply is interrupted (fuse blows or the battery is disconnected), the preset
channels will be erased.
0#8087'DQQMࡍࠫ㧞㧜㧝㧝ᐕ㧝㧝㧠ᣣޓ㊄ᦐᣣޓඦᓟ㧟ᤨ㧝㧠ಽ