the rubber actuator (1) is cut too long, the storage compartment door
(3) will not close properly. Excessive force to close the storage
compartment door (3) may cause the door latch to break.
•
Per the table below, cut the rubber actuator (1) to the proper length
based on the thickness (4) measured in the third step.
Approximate
Thickness of Transmitter
(GDO)
inches
mm
Cut to Bottom of
Notch
Less Than
1/4
6.35
No Cut
7/8
22.00
Notch 2
1.0
26.00
Notch 4
1–3/16
32.00
Notch 6
•
Reinstall the rubber actuator (1) in the storage compartment (7) by
twisting and pushing it back into the slot.
•
Install the transmitter (6) on to storage compartment door (3)
aligning the actuator control (8) with the rubber actuator (1). Close
the storage compartment door (3) to verify proper fit. Do not force
the storage compartment door (3) or you may break the door latch. If
the rubber actuator (1) is the proper length the storage compartment
door will close. Press the storage compartment door (3) to activate
the transmitter (6).
Illuminated visor mirror (if equipped)
Lift the mirror cover to turn on the
visor mirror lamps.
2006 Tribute
(j14)
Owners Guide (post-2002-fmt)
USA
(fus)
Driver Controls
46