Wireless Control; Accessory Power Outlets; See Section 2 of your Owner Manual.- Page 13

13

HomeLink

®

Wireless Control

System

The HomeLink system can store three

frequencies for a garage door opener,

entry door lock, security system, etc. 

To program, with the engine Off:

• Press and hold the two outer buttons

on the HomeLink until the indicator

light flashes; then release the buttons

(about 20 seconds — do not hold for

more than 30 seconds); do not repeat

this step for the second or third

devices added.

• Hold the end of your hand-held trans-

mitter up to three inches away from

the surface of the HomeLink. Hold its

button and the button you wish to

assign it to on the HomeLink system.

• Continue holding both buttons (up to

90 seconds); the indicator light will

begin blinking slowly, then more quick-

ly. Programming is complete when

the HomeLink light flashes rapidly.

• Release both buttons.

• Press and hold the HomeLink button

again. If the indicator stays lit con-

stantly, programming is complete.

• Continue programming additional

devices using the remaining two

HomeLink buttons, but do not simul-

taneously press the two outer buttons

on the HomeLink again.

If the HomeLink indicator blinks rapidly

for two seconds and remains on during

programming, it indicates that your

device (usually a garage door opener)

has a “rolling code.”

See Section 2 of your Owner Manual.

Accessory Power Outlets

Your vehicle is equipped with 12-volt

outlets. One is located on the center

console below the climate controls. The

second outlet is located inside the cen-

ter storage console. On 6-passenger

models, the second outlet is located in

the flip/fold console. Use them to power

cellular phones, CB radio, etc. See your

Owner Manual for full safety and war-

ranty cautions.

See Section 3 of your Owner Manual.