Always check the Owner’s Manual for more operating information and safety features ; WARNINGS: When using a ; rear-facing infant-safety seat- Page 6

S E A T S

Always check the Owner’s Manual for more operating information and safety features 

Seats

Seats/

Console

Quick Tips

Mazda

Mazda B-Series Truck

page 10
page 11

WARNINGS: When using a 
rear-facing infant-safety seat
or a front-facing child seat,
always set the passenger seat
air bag deactivation switch to
OFF position, an infant 
or child is in serious 
danger of being injured 
or killed if front passenger
air bag is deployed 
If you install a front-facing
child-seat, put it in the outboard
seat and slide it all the way
rearward, set passenger air
bag deactivation switch to 
OFF position
For Cab-Plus vehicles, do not 
put child restraints in the center
facing jump seats, for complete
details see Owner’s Manual

Console (Split bench)
1. Coin tray
2. Map storage
3. Storage compartment

Child-safety seat

To install, use dual-locking mode
retractor safety belts; see Owner’s
Manual for proper installation 
and child seat tether and 
LATCH system instructions 

WARNING: Use age appropriate
child restraints, see Owner’s
Manual and state or province laws

1

2

Seats

1. Fore/aft adjustment

Raise lever and hold, slide 
seat, release lever

2. Seatback angle

To adjust: Lift and hold lever,
lean forward or backward 
to tilt seat, release lever

WARNINGS: Do not adjust 
seats while driving
Safety belts must always 
be worn when vehicle 
is in motion
All air bags are supplemental
and do not replace safety 
belt usage
Always wear your 
safety belt and properly 
secure children

Shoulder belt 
height 
adjustment

To raise belt: 
Slide adjuster up
To lower belt: 
Push release 
button (

3

) and 

slide down

WARNING: 
Make sure 
adjuster locks 
in one of 
its positions

*Denotes optional equipment

Safety belt emergency
locking mode

Belts lock only on hard 
acceleration, braking, cornering 
or impacts of about 5 mph 
or more

Automatic locking mode 
(front passenger safety 
belt only)

Must be used when installing
child-safety seat
To activate: Pull webbing fully 
out of retractor until click is heard;
belt will only tighten
To disengage: Unbuckle belt and
allow webbing to retract fully

3

3

2

1