Audio Operation; Audio Sound Adjustment; Preset channel tuning - Page 68

67

Audio Operation

n

Manual tuning

Pressing the seek tuning button will change the frequency higher or lower.

n

Seek tuning

Pressing and holding the seek tuning button (

,

) will cause the tuner to seek a higher 

or lower frequency automatically.

Note

If you continue to press and hold the button, the frequency will continue changing without 
stopping.

n

Scan tuning

Press the (SCAN) button to automatically sample strong stations.
Scanning stops at each station for about 5 seconds. To hold a station, press the (SCAN) 
button again during this interval. 

n

Preset channel tuning 

The 8 preset channels can be used to store 8 AM and 16 FM stations.

1. To set a channel first select AM, FM1, or FM2. Tune to the desired station.

2.Select any channel preset on-screen button for about 2 seconds until a beep sound is 

heard. The selected preset channel number and station frequency will be displayed. The 
station is now held in the memory.

3.Repeat this operation for the other stations and bands you want to store. To tune one in the 

memory, select AM, FM1, or FM2 and then press its channel preset button. The station 
frequency and the channel number will be displayed.

Note

If the power supply is interrupted (fuse blows or the battery is disconnected), the preset 
channels will be canceled.

n

Auto memory tuning

This is especially useful when driving in an area where the local stations are not known. Addi-
tional AM/FM stations can be stored without disturbing the previously set channels.

Select and hold the 

 on-screen button for about 2 seconds until a beep sound is heard; 

the system will automatically scan and temporarily store up to 8 stations with the strongest 
frequencies in each selected band in that area.

n

Audio Sound Adjustment

Refer to “Power/Volume/Sound Controls”

%:A'#DQQM2CIG6JWTUFC[/CTEJ2/