74
Bef
ore
Use
Getting
star
ted
Routing
Ad
dress
Book
Vo
ic
e
Recogn
ition
Na
vigation
Set Up
RDM-TMC
A
u
dio Operation
N
a
vigation
Set Up
n
Tuning
The radio has the following tuning methods: Manual, Seek, Scan, Preset channel, and Auto
memory tuning. The easiest way to tune stations is to set them on preset channels.
Note
l
If the FM broadcast signal becomes weak, reception automatically changes from STEREO
to MONO for reduced noise, and the STEREO indicator will go out.
l
To clear the information, press the NAVI button.
l
If the power supply is interrupted (fuse blows or the battery is disconnected), the preset
channels will be canceled.
n
Manual tuning
Pressing the seek tuning button will change the frequency higher or lower.
n
Seek tuning
Pressing and holding the seek tuning button (
,
) will cause the tuner to seek a higher
or lower frequency automatically.
Note
If you continue to press and hold the button, the frequency will continue changing without
stopping.
n
Scan tuning
Press the (SCAN) button to automatically sample strong stations.
Scanning stops at each station for about 5 seconds. To hold a station, press the (SCAN)
button again during this interval.
n
Preset channel tuning
The 8 preset channels can be used to store 8 AM and 16 FM stations.
1. To set a channel first select AM, FM1, or FM2. Tune to the desired station.
2.Select any channel preset on-screen button for about 2 seconds until a beep sound is
heard. The selected preset channel number and station frequency will be displayed. The
station is now held in the memory.
3.Repeat this operation for the other stations and bands you want to store. To tune one in the
memory, select AM, FM1, or FM2 and then press its channel preset button. The station
frequency and the channel number will be displayed.
Note
If the power supply is interrupted (fuse blows or the battery is disconnected), the preset
channels will be canceled.
'<C)%FSSO4EKI1SRHE]2SZIQFIV41