When Driving; Switches and Controls; Do not release - Page 186

4–60

When Driving

Switches and Controls

 Pre-programming the HomeLink 

System

     NOTE

  It is recommended that a new battery be 
placed in the hand-held transmitter of the 
device being programmed to HomeLink 
for quicker training and accurate 
transmission of the radio-frequency signal.

y

 Verify that there is a remote control 

transmitter available for the device you 
would like to program.

y

 Disconnect the power to the device.

 Programming the HomeLink 

System

CAUTION

  When programming a garage door 
opener or a gate, disconnect the power 
to these devices before performing 
programming. Continuous operation 
of the devices could damage the 
motor.

  The HomeLink system provides 3 buttons 
which can be individually selected and 
programmed using the transmitters for 
current, on-market devices as follows:

   1.   Disconnect power to the device being 

programmed.

   2.   Position the end of your hand-held 

transmitter 2.5—7.5 cm (1—3 inches) 
away from the HomeLink button you 
wish to program while keeping the 
indicator light in view.

   3.   Simultaneously  press  and  hold  both 

the chosen HomeLink and hand-held 
transmitter buttons.

Do not release 

the buttons until step 3 has been 
completed.

   NOTE

  Some gate operators and garage door 
openers may require you to replace this 
Programming Step 2 with procedures 
noted in the “Gate Operator/Canadian 
Programming” section.

   4.   After  the  HomeLink  indicator  light 

changes from a slow to a rapidly 
blinking light, release both the 
HomeLink and hand-held transmitter 
buttons.

   NOTE

  If the HomeLink indicator light does not 
change to a rapidly blinking light, contact 
HomeLink at 

 www.homelink.com 

 or call 

1-800-355-3515

 for assistance.

   5.   Connect power to the device being 

programmed.

   6.   Firmly press and hold the programmed 

HomeLink button for fi ve seconds, 
and then release it. Perform this 
operation two times to activate the door 
or gate. If the door or gate does not 
activate, press and hold the just-trained 
HomeLink button and observe the 
indicator light.

If the indicator light stays on 
constantly, programming is complete 
and your device should activate when 
the HomeLink button is pressed and 
released.

   NOTE

  To program the remaining two HomeLink 
buttons, begin with “Programming”

 — 

step 1

/C\FCA&('#*A'FKVKQPKPFD

/C\FCA&('#*A'FKVKQPKPFD