When Driving; Switches and Controls; rapidly for - Page 187

4–61

When Driving

Switches and Controls

  If the indicator light blinks  

rapidly for 

two seconds and then turns to a constant 
light, continue with “Programming” 
steps 7—9

  to complete the programming 

of a rolling code equipped device (most 
commonly a garage door opener).
   7.   At the garage door opener receiver 

(motor-head unit) in the garage, locate 
the “learn” or “smart” button. This can 
usually be found where the hanging 
antenna wire is attached to the motor-
head unit.

   8.   Firmly press and release the “learn” or 

“smart” button. (The name and color of 
the button may vary by manufacturer.) 

   NOTE

  Complete the programming within 30 
seconds.

   9.   Return  to  the  vehicle  and  fi rmly  

press, 

hold for two seconds and release

   the 

programmed HomeLink button. Repeat 
the “ 

press/hold/release

 ” sequence a 

second time, and, depending on the 
brand of the garage door opener (or 
other rolling code equipped device), 
repeat this sequence a third time to 
complete the programming process.

  HomeLink should now activate your 
rolling code equipped device.

   NOTE

  To program the remaining two HomeLink 
buttons, begin with “Programming” 

—

step 1

  For questions or comments, please contact 
HomeLink at

www.homelink.com

  or  

1-

800-355-3515

 .

 Gate  operator/Canadian 

Programming

    Canadian  radio-frequency  laws  require 
transmitter signals to “time-out” (or quit) 
after several seconds of transmission 
— which may not be long enough for 
HomeLink to pick up the signal during 
programming. Similar to this Canadian 
law, some U.S. gate operators are designed 
to “time-out” in the same manner.

  If you live in Canada or you are having 
diffi culties programming a gate operator 
by using the “Programming” procedures 
(regardless of where you live),

replace 

“Programming HomeLink” step 3

   with 

the following: 

   NOTE

  If programming a garage door opener or 
gate operator, it is advised to unplug the 
device during the “cycling” process to 
prevent possible overheating.

  Continue to press and hold the HomeLink 
button while you

press and release 

— every two seconds

  (“cycle”) your 

hand-held transmitter until the frequency 
signal has successfully been accepted by 
HomeLink. (The indicator light will fl ash 
slowly and then rapidly.)
  Proceed with “Programming” step 4 to 
complete.

 Operating the HomeLink System

    Press  the  programmed  HomeLink  button 
to operate a programmed device. The 
code will continue being transmitted for a 
maximum of 20 seconds.

/C\FCA&('#*A'FKVKQPKPFD

/C\FCA&('#*A'FKVKQPKPFD