When Driving; Switches and Controls; for two seconds and then turns - Page 184

4–56

When Driving

Switches and Controls

NOTE

Some gate operators and garage door 

openers may require you to replace this 

Programming Step 2 with procedures 

noted in the “Gate Operator/Canadian 

Programming” section.

4.  After the HomeLink indicator light 

changes from a slow to a rapidly 

blinking light, release both the 

HomeLink and hand-held transmitter 

buttons.

NOTE

If the HomeLink indicator light does not 

change to a rapidly blinking light, contact 

HomeLink at 

www.homelink.com

 or call 

1-800-355-3515

 for assistance.

5.  Connect power to the device being 

programmed.

6.  Firmly press and hold the programmed 

HomeLink button for five seconds, 

and then release it. Perform this 

operation two times to activate the door 

or gate. If the door or gate does not 

activate, press and hold the just-trained 

HomeLink button and observe the 

indicator light.

  If the indicator light stays on 

constantly, programming is complete 

and your device should activate when 

the HomeLink button is pressed and 

released.

NOTE

To program the remaining two HomeLink 

buttons, begin with “Programming”

— 

step 1

  If the indicator light blinks 

rapidly 

for two seconds and then turns 

to a constant light, continue with 

“Programming” steps 7—9

 to 

complete the programming of a rolling 

code equipped device (most commonly 

a garage door opener).

7.  At the garage door opener receiver 

(motor-head unit) in the garage, locate 

the “learn” or “smart” button. This can 

usually be found where the hanging 

antenna wire is attached to the motor-

head unit.

8.  Firmly press and release the “learn” or 

“smart” button. (The name and color of 

the button may vary by manufacturer.) 

NOTE

Complete the programming within 30 

seconds.

9.  Return to the vehicle and firmly 

press, 

hold for two seconds and release

 the 

programmed HomeLink button. Repeat 

the “

press/hold/release

” sequence a 

second time, and, depending on the 

brand of the garage door opener (or 

other rolling code equipped device), 

repeat this sequence a third time to 

complete the programming process.

HomeLink should now activate your 

rolling code equipped device.

NOTE

To program the remaining two HomeLink 

buttons, begin with “Programming”

— 

step 1

For questions or comments, please contact 

HomeLink at 

www.homelink.com

 or 

1-

800-355-3515

.

Mazda3_8FA4-EA-15G_Edition1.indb   56

2015/05/11   14:00:54