Interior Features; Audio System- Page 292

5–30

Interior Features

Audio System

           Operating the Radio

Band selector button

Channel preset buttons

Scan button

Auto memory button

Tuning button

Audio display

    Radio ON

    Press a band selector button ( 

 )  to 

turn the radio on.

  Band  selection

    Successively  pressing  the  band  selector 
button ( 

 ) switches the bands as 

follows: FM1

ĺ

FM2

ĺ

AM.

  
  The selected mode will be indicated.

   NOTE

  If the FM broadcast signal becomes weak, 
reception automatically changes from 
STEREO to MONO for reduced noise.

  Tuning

    The radio has the following tuning 
methods: Manual, Seek, Scan, Preset 
channel, and Auto memory tuning. The 
easiest way to tune stations is to set them 
on preset channels.

  Manual  tuning

    Select the station by pressing the tuning 
button (   ,     )  lightly.

  Seek  tuning

    Automatic search for radio stations starts 
when the tuning button (   ,     ) is pressed 
until a beep sound is heard. The search 
stops when a station is found.

   NOTE

  If you continue to press and hold the 
button, the frequency will continue 
changing without stopping.

  Scan  tuning

    Press and hold the scan button ( 

 )  to 

automatically sample strong stations. 
Scanning stops at each station for about 5 
seconds. To hold a station, press and hold 
the scan button ( 

 ) again during this 

interval.

  Preset  channel  tuning

    The 6 preset channels can be used to store 
6 AM and 12 FM stations.

   1.   To  set  a  channel 

¿

 rst select AM, FM1, 

or FM2. Tune to the desired station.

   2.   Press a channel preset button for 

about 2 seconds until a beep is heard. 
The preset channel number or station 
frequency will be displayed. The 
station is now held in the memory.