Driving Your Mazda; Switches and Controls; Pre-programming the HomeLink - Page 138

5-44

Driving Your Mazda

Switches and Controls

Form No. 8R29-EA-02I

▼

Pre-programming the HomeLink 
System

•

Verify that there is a remote control 
transmitter available for the device you 
would like to program.

•

Disconnect the power to the device.

▼

Programming the HomeLink 
System

The HomeLink system provides 3 buttons 
which can be individually selected and 
programmed using the transmitters for 
current, on-market devices as follows:

1. Press and hold the two outer 

HomeLink buttons (buttons one and 
three) - releasing only when the 
indicator light begins to flash (after 20 
seconds).

 Do not

 hold the buttons for 

longer than 30 seconds and

 do not 

repeat step 1

 to program a second and/

or third hand-held transmitter to the 
remaining two HomeLink buttons.

2. Position the end of your hand-held 

transmitter 2.5—7.5 cm (1—3 inches) 
away from the HomeLink button you 
wish to program while keeping the 
indicator light in view.

3. Simultaneously press and hold both the 

chosen HomeLink and hand-held 
transmitter buttons. 

 Do not release the 

buttons until step 4 has been 
completed.

NOTE

FCC ID: NZLSTDHL3
CANADA:4112104541A
This device complies with FCC rules 
part 15. Operation is subject to the 
following conditions:
1- This device may not cause any 
harmful interference and
2- This device must accept any 
interference that may be received 
including interference that may cause 
undesired operation.

NOTE

The programming will not be erased 
even if the battery is disconnected.

NOTE

It is recommended that a new battery 
be placed in the hand-held transmitter 
of the device being programmed to 
HomeLink for quicker training and 
accurate transmission of the radio-
frequency signal.

When programming a garage door 
opener or a gate, disconnect the power 
to these devices before performing 
programming, as continuous operation 
of the devices could damage the motor.

NOTE

Some gate operators and garage door 
openers may require you to replace this 
Programming Step 3 with procedures 
noted in the "Gate Operator/Canadian 
Programming" section.

CAUTION

J56J_8R29_EA_02I_Edition4.book  Page 44  Monday, April 21, 2003  3:44 PM