Always check the Owner’s Manual for more operating information and safety features ; 1. Head restraint; WARNING: Head restraints- Page 7

S E A T S

Always check the Owner’s Manual for more operating information and safety features 

Seats

Seats

Quick Tips

2002 Mazda

Millenia

page 12
page 13

Revised January 14, 2002

1. Head restraint

To raise/lower: Press release
button (

4

) and pull up/

push down
To move forward/aft: Rotate
(driver’s seat only)

WARNING: Head restraints
should always be inserted 
and properly adjusted before
driving, see Owner’s Manual

Power seats

2. Raise/lower front of seat

Move front of switch vertically

Fore/aft adjustment

Move switch horizontally 

Raise/lower rear of seat

Move rear of switch vertically 

Raise/lower seat cushion

Move center of switch vertically

3. Seatback angle

Rotate fore/aft for desired angle

Lumbar support

(driver’s seat only)
Located at front of 
center console

Press top/bottom of switch to
increase/decrease firmness

WARNINGS: Always wear 
your safety belt and properly
secure children 12 and under 
in the rear seat
If you choose to install a 
forward-facing child-safety 
seat in the front seating 
positions, move vehicle seat 
as far back as possible
All air bags are supplemental
and do not replace safety 
belt usage
Do not adjust seat while driving

Shoulder belt
height 
adjustment

To raise/lower belt,
press button (

5

)

and move up/down

WARNING: Make 
sure adjuster 
locks in 
position

4

1

2

3

Dual locking mode
lap/shoulder belt retractor
(front passenger and rear
outboard safety belts only)

Emergency locking mode: Belt
locks only on hard braking/
cornering or impacts of about 
5 mph or more

Automatic locking mode: 
Must be used when installing 
child-safety seat
To activate: Pull webbing fully 
out of retractor until click is 
heard; belt will only tighten 
To disengage: Unbuckle belt and
allow webbing to retract fully

Child-safety seat

Some child restraint systems are
equipped with tethers that must
be installed on one of the three
anchors on the rear seats
To install in rear outboard seats:
Use dual locking mode retractor
safety belt; see Owner’s Manual
for proper installation and child
seat tether instructions

WARNINGS: Read all information
and warnings on child-safety
seat and in Owner’s Manual
before using child-safety seat
You are required by law to use
safety restraints for children in
U.S. and Canada, check your
local and state or provincial
laws for specific requirements
regarding the safety of children
in your vehicle
Never place rear-facing child-
safety seat in front seat

5