When Driving; press and release ―; every two seconds- Page 188

2021 Mazda MX- 5 Miata Mx 5 Owners Manual

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

When Driving
Customer Information and Reporting Safety Defects
background image

Gate operator/Canadian
Programming

Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission ―
which may not be long enough for
HomeLink to pick up the signal during
programming. Similar to this Canadian
law, some U.S. gate operators are designed
to “time-out” in the same manner.
 
If you live in Canada or you are having
difficulties programming a gate operator
by using the “Programming” procedures
(regardless of where you live), 

replace

“Programming HomeLink” step 3

 with

the following:

NOTE

If programming a garage door opener or
gate operator, it is advised to unplug the
device during the “cycling” process to
prevent possible overheating.

Continue to press and hold the HomeLink
button while you 

press and release ―

every two seconds

 (“cycle”) your

hand-held transmitter until the frequency
signal has successfully been accepted by
HomeLink. (The indicator light will flash
slowly and then rapidly.)
Proceed with “Programming” step 4 to
complete.

Operating the HomeLink System

Press the programmed HomeLink button
to operate a programmed device. The code
will continue being transmitted for a
maximum of 20 seconds.

Reprogramming the HomeLink
system

To program a device to HomeLink using a
HomeLink button previously trained,
follow these steps:
1. Press and hold the desired HomeLink

button. 

DO NOT

 release the button.

2. The indicator light will begin to flash

after 20 seconds. Without releasing the
HomeLink button, proceed with
“Programming” - step 1.

Erasing Programmed HomeLink
Buttons

To erase the existing programming from
all three operating channels, press and
hold the two outside buttons (

) on

the auto-dimming mirror until the
HomeLink indicator light begins to flash
after approximately 10 seconds.
Verify that the programming has been
erased when you resell the vehicle.

When Driving

Switches and Controls

4-61

MX-5_8JS9-EA-20K_Edition1_old

2020-8-28 13:50:01

Detailed Information for 2021 Mazda MX- 5 Miata Mx 5 Owners Manual

Lists of information found in 2021 Mazda MX- 5 Miata Mx 5 Owners Manual - Page 188

  • 1. Press and hold the desired HomeLink button.
  • 2. The indicator light will begin to flash after 20 seconds.
  • 1. ▼ Erasing Programmed HomeLink Buttons To erase the existing programming from all three operating channels, press and hold the two outside buttons ( , ) on the auto-dimming mirror until the HomeLink indicator light begins to flash after approximately 10 seconds.

Related Documents for 2021 Mazda MX- 5 Miata Mx 5 Owners Manual