Wiper Blade Replacement; Vehicle Care; Front Wiper Blade- Page 286

2013 Buick enclave Owner Manual

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

Seats and Restraints
Instruments and Controls
Driving and Operating
Vehicle Care
Customer Information
background image

Black plate (24,1)

Buick Enclave Owner Manual - 2013 - crc - 11/14/12

10-24

Vehicle Care

.

To check the P (Park)
mechanism's holding ability:
With the engine running, shift to
P (Park). Then release the
parking brake followed by the
regular brake.

Contact your dealer if service is
required.

Wiper Blade Replacement

Front Wiper Blade

Windshield wiper blades should be
inspected for wear or cracking. See

Maintenance Schedule on
page 11

3

.

Replacement blades come in
different types and are removed in
different ways. For the proper type
and size, see

Maintenance

Replacement Parts on page 11

13

.

To replace the wiper blade
assembly:

1. Pull the windshield wiper

assembly away from the
windshield.

2. Squeeze the tabs on each side

of the wiper blade assembly and
slide the assembly off the end of
the wiper arm.

3. Install the new blade onto the

arm connector and make sure
the tabs are fully set in the
locked position.

Allowing the wiper blade arm to
touch the windshield when no
wiper blade is installed could
damage the windshield. Any
damage that occurs would not

be covered by your warranty. Do
not allow the wiper blade arm to
touch the windshield.

4. Repeat the steps for the other

blade.

Rear Wiper Blade

To replace the rear wiper blade:

1. Pull the wiper blade assembly

away from the backglass.

The rear wiper blade will not lock
in a vertical position so care
should be used when pulling it
away from the vehicle.

Detailed Information for 2013 Buick enclave Owner Manual

Lists of information found in 2013 Buick enclave Owner Manual - Page 286

  • 1. Pull the windshield wiper assembly away from the windshield.
  • 2. Squeeze the tabs on each side of the wiper blade assembly and slide the assembly off the end of the wiper arm.
  • 3. Install the new blade onto the arm connector and make sure the tabs are fully set in the locked position.
  • 4. Repeat the steps for the other blade.
  • 1. Pull the wiper blade assembly away from the backglass.