17
The Rainsense™ II windshield wipers use a moisture sensor to automatically operate the
wipers when needed, depending on driving conditions and the sensitivity setting. If the system
is left on for long periods, an occasional wipe may occur without any moisture on the
windshield to indicate the system is activated.
The headlamps and parking lamps also will be turned on automatically when the Rainsense
wipers are active if the exterior lamp control switch is in the AUTO position. The controls for the
windshield wipers are located on the multifunction stalk on the left side of the steering column.
Rainsense™ II Windshield Wipers (if equipped) and Heated Washer
Fluid (if equipped)
(Washer Fluid):
Push the paddle on
top of the multifunction
lever to spray washer
fluid on the windshield.
(Sensitivity Setting):
Rotate
the control band up to one of the
sensitivity levels to activate the
Rainsense function. The wipers
activate more often as the band
is rotated upward.
(High):
Rotate the
control band
up to this posi-
tion to turn the
wipers on the
High setting.
(Heated Washer
Fluid):
Slide and
release this switch to
start four automatic
heated wash/wipe
cycles.The first
cycle may take up
to 45 seconds to
occur before the
washer fluid
is heated. The
remaining cycles
may take up to 20
seconds to occur.
The system
determines the
amount of fluid and
activates the wipers.
To cancel any
remaining wash/wipe
cycles, slide and
release the switch
again.
(Low):
Rotate the
control band
up to this
position to turn
the wipers on
the Low
setting.
(Off):
Rotate the control
band to this position to turn
off the wipers.
(Mist):
Rotate the
control band down to
this position to turn the
wipers on for one wipe.
See Section 3 of your Owner Manual.
Note:
Turn off the
Rainsense wipers before
entering an automatic
car wash to prevent
wiper damage.
93763_08a_Lucerne_GTK_REV.qxd:Lucerne 2007 A 5/30/07 11:49 AM Page 17