Bulb Replacement; Halogen Bulbs; High Intensity Discharge (HID) Lighting- Page 278

2015 Buick Regal Owner Manual

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

In Brief
Seats and Restraints
Instruments and Controls
Driving and Operating
Vehicle Care
background image

Black plate (31,1)

Buick Regal Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-

7576024) - 2015 - CRC - 9/15/14

Vehicle Care

10-31

Bulb Replacement

For the proper type of replacement
bulbs, see

Replacement Bulbs on

page 10-33

.

For any bulb

changing procedure

not listed in this section, contact
your dealer.

Halogen Bulbs

{

Warning

Halogen bulbs have pressurized
gas inside and can burst if you
drop or scratch the bulb. You or
others could be injured. Be sure
to read and follow the instructions
on the bulb package.

High Intensity Discharge
(HID) Lighting

{

Warning

The high intensity discharge
lighting system operates at a very
high voltage. If you try to service
any of the system components,
you could be seriously injured.
Have your dealer or a qualified
technician service them.

After an HID headlamp bulb has
been replaced, the beam might be a
slightly different shade than it was
originally. This is normal.

Headlamps, Front Turn
Signal and Parking
Lamps

Low Beam Headlamp/Daytime
Running Lamp (Base)

1. For the driver side bulb, remove

the windshield washer bottle
filler neck by firmly pulling it
straight up and out of the bottle.

2. Remove the cap from the back

of the headlamp assembly.

3. Disconnect the electrical

connector.

4. Remove the bulb socket from

the headlamp assembly.

5. Reverse steps 1

4 to install.

High/Low-Beam Headlamps
(Uplevel)

The high/low-beam headlamps on
the uplevel headlamp system are
High Intensity Discharge (HID) and
should be replaced at the dealer.

Detailed Information for 2015 Buick Regal Owner Manual

Lists of information found in 2015 Buick Regal Owner Manual - Page 278

  • 1. For the driver side bulb, remove the windshield washer bottle filler neck by firmly pulling it straight up and out of the bottle.
  • 2. Remove the cap from the back of the headlamp assembly.
  • 3. Disconnect the electrical connector.
  • 4. Remove the bulb socket from the headlamp assembly.
  • 5. Reverse steps 1 – 4 to install.