Operation Manual; 3 Setup; DBC Network Bridge- Page 16

Operation Manual

DBC Network Bridge

page 16

3.1 Unpack and Install Your 
DBC Network Bridge

Please unpack and inspect your product for any 
damage that may have occurred during transit. 
If damage is found, notify the transportation 
company immediately. Only you can initiate a 
claim for shipping damage. Crown will be 
happy to help as needed. Save the shipping 
carton as evidence of damage for the shipper’s 
inspection. 

We also recommend that you save all packing 
materials so you will have them if you ever 
need to transport the unit. 

Never ship the 

unit without the factory pack.

YOU WILL NEED (not supplied):

•

Input wiring cables 

•

Network cables 

•

Rack for mounting the DBC Network 
Bridge (or a stable surface for stacking)

WARNING: Before you start to set up 
your DBC Network Bridge, make sure 
you read and observe the Important 
Safety Instructions found at the begin-
ning of this manual.

CAUTION: Before you begin, make sure 
your DBC Network Bridge is discon-
nected from the power source.

Use a standard 19-inch (48.3 cm) equipment 
rack (EIA RS-310B). See Figure 3.1 for dimen-
sions. 
You may also stack units without using a 
cabinet.
NOTE: When transporting, units should be sup-
ported at both front and back.

3.2 Connecting to AC Mains 

WARNING: The third (ground) prong of 
the AC power cord connector is a 
required safety feature. Do not attempt 
to disable this ground connection by 
using an adapter or other methods.

3 Setup

Figure 3.1 Dimensions