Operation Manual; 4 Operation; Scene Screen- Page 22

Operation Manual

DBC Network Bridge

page 22

4 Operation

4.3 Navigating the LCD Control Screen

4.3.1 Functions, Controls and Screens

The LCD Control Screen and its controls let you view and set up 
various parameters in the DBC Network Bridge. Settings made on 
the LCD screen are duplicated in IQwic software, and vice-versa. 
(DSP parameters cannot be adjusted with the LCD Control 
Screen. That is done in IQwic.) 

Figure 4.3 LCD Control Screen and Its Controls.

Left-to-right: Menu/Select Button, Prev Button, 

Next Button, LCD Control Screen

Figure 4.3 shows the LCD Control Screen and its controls. Its 
functions are described below. 

The LCD Control Screen shows

:

32 Preset numbers
32 Scene numbers
Analog or digital audio input selections
IQ Address / IP Address/ Subnet Mask/MAC Address
Firmware Info
Errors

On power-up, the LCD Control Screen displays the Crown logo 
and DBC logo. The screen defaults to the Preset display.

Scene Screen

 is used to select Scenes.

Preset Screen

 is used to select Presets.

Address Screen

 is used to read addresses and subnet mask.

Input Board Menu

 is used to select input signals.

Getting around in the Menu is intuitive. Here are the basic opera-
tions:

• Hold the 

Menu/Select

 button to cycle through the Preset 

screen, Scene screen, Address screen, Input Board Menu, Firm-
ware Info screen, and back to the Preset screen.

• Press 

Next 

to go to a higher-numbered Preset, Scene, or 

Input. Presets and Scenes loop around from 1 to 32.

• Press 

Prev

to go to a lower-numbered Preset, Scene, or Input. 

Presets and Scenes loop around from 32 back to 1.

• Press 

Menu/Select 

within 2 seconds after pressing 

Next

 or 

Prev

 to make a selection.

Preset 01  Active

PRESET 1

Scene 01  No Data

SCENE 1

IQ: 001
IP: 192.168.001.001
Sub:255.255.248.000
MAC:00-60-2B-02-8F-C0 

INPUT BOARD MENU
Digital/Surround

Analog/Surround

Analog Auxiliary 

Firmware Info Screen

 displays the version of the 

Control firmware and SHARC firmware.

FIRMWARE INFO

Control:  1.110
SHARC:    2.100 

Once the 

Menu/Select

 button is released, the 

Next

 and 

Prev 

arrow buttons are used to adjust the parameter. On releasing the 

Menu/Select

 button, you have two seconds to press the 

Next 

or 

Prev

 button before the display changes back to default. When 

the parameter is adjusted to the desired value, press the 

Menu/

Select

 button to store the setting.

Internal errors are automatically displayed on the LCD Control 
Screen. If an error is displayed, call Tech Support at Crown and 
provide them the error number.

Operation examples and the Menu Tree are on the next page.