2. Test drive your truck in an uncongested area.; If anything doesn't look or feel right, don't drive the truck. Report the; problem to your supervisor.- Page 16

Daily Safety Check   30

2.    Test drive your truck in an uncongested area.

• Try the hydraulic functions.
• Check that the steering is easy and smooth.
• Drive the truck slowly in both directions.
• Drive through the full speed range in both forward

and reverse.

• Check braking and plugging distances in forward

and reverse.  Load size and floor conditions can affect

these distances.

• Know the distance it takes to stop before you start 

working.  If the braking distance is too long to stop 

safely, don't drive the truck.

• Check wire guidance operation.

If anything doesn't look or feel right, don't drive the truck. Report the
problem to your supervisor.

You can get checklist forms from your Crown dealer

(part no. OF-3772).  Used properly, this checklist can alert

service people to needed repairs.

Daily Safety Check

29   Daily Safety Check

CHECK YOUR TRUCK BEFORE STARTING WORK

You must make sure your truck is safe to use.

1. Walk around your truck and check it over.

• Inspect your harness, tether, snap hooks and mounting

   points.  Have them replaced if they look damaged or 

   worn or have ever been used to stop a fall.
• Clean the safety shield and keep it clear.
• Check to make sure the battery is charged, water level

is OK and vent caps are in place.  Don't use an open 

flame to check the battery.

• Make certain the battery retainers on both sides of the

truck are properly installed.

• See that all wheels are in good condition.
• Make sure the flashing light is working.
• Check that both forks are secure and not bent, cracked

or badly worn.

• Inspect lift chains for damage.
• Look under the truck for signs of hydraulic leaks.
• Turn the key to TEST.  See that the alarm and all display

lights are working.  Try the horn.

• Make sure the power disconnect works.