Operation Manual; Get Started; XLS Series - Page 5

XLS Series 

Power Amplifi ers

page 5

Operation Manual

LowPass Mode

When using the “LowPass Mode”, the amplifi er is confi gured to use a LowPass 
Filter on Channel 1 and Channel 2 at the selected frequency.

Before you get started ensure that you:

  1.   Connect Left/Right signal source to Channel 1 and Channel 2 using 

either the XLR, ¼ Inch, or RCA connectors.

  2.   Connect a speaker to each channel output using Speakon

®

, Banana 

Plugs, or bare wire.

Follow these quick steps to confi gure the amplifi er for “HighPass Mode”:

  1.   Hold the “Mode/Menu” button down for 3 sec until the LCD screen 

displays “Amp Mode <More>”.

  2.   Press the “Mode/Menu” button to begin confi guring the Amp Mode.

  3.   Press the “Next” button until the LCD screen displays “Stereo”. Now press the “Mode/Menu” button to confi rm.

  4.   Now press the “Next” button until the LCD screen displays “LowPass” and press the “Mode/Menu” button to confi rm.

  5.   Now use the “Previous” or “Next” button to select your desired crossover point.  

  6.   Once you have selected your crossover point, press the “Mode/Menu” button to confi rm your selection. The LCD screen should now read “Stereo LowPass”.

HighPass Mode

When using the “HighPass Mode”, the amplifi er is confi gured to use a HighPass 
Filter on Channel 1 and Channel 2 at the selected frequency. 

Before you get started ensure that you:

  1.   Connect Left/Right signal source to Channel 1 and Channel 2 using either 

the XLR, ¼ Inch, or RCA connectors.

  2.   Connect a speaker to each channel output using Speakon

®

, Banana Plugs, 

or bare wire.

Follow these quick steps to confi gure the amplifi er for “HighPass Mode”:

  1.   Hold the “Mode/Menu” button down for 3 sec until the LCD screen 

displays “Amp Mode <More>”.

  2.   Press the “Mode/Menu” button to begin confi guring the Amp Mode.

  3.   Press the “Next” button until the LCD screen displays “Stereo”. Now press the “Mode/Menu” button to confi rm.

  4.   Now press the “Next” button until the LCD screen displays “HighPass” and press the “Mode/Menu” button to confi rm.

  5.   Now use the “Previous” or “Next” button to select your desired crossover point.  

  6.   Once you have selected your crossover point, press the “Mode/Menu” button to confi rm your selection. The LCD screen should now read “Stereo HighPass”.

Get Started