Operation Manual; Get Started; XTi2 Series - Page 4

XTi2 Series 

Power Amplifiers

Operation Manual

page 4

Stereo DSP Off

This is the default mode the amplifier is set to from the factory. The 
amplifier is configured for stereo mode with all processing disabled.

1.  Connect Left/Right signal source to Channel 1 and Channel 2 using 

the XLR connectors.

2.  Connect a speaker to each channel output using Speakon

®

, Banana 

Plugs, or bare wire.

Factory Preset #2: BRIDGE

Putting the amplifier in 

BRIDGE

 (bridge-mono) mode delivers the power of 

both amp channels into a 

single

 8 or 4 ohm load.  The XTi2 Series amplifiers 

come pre-loaded with a preset that makes it easy to configure the amplifier for 
this operation.

Before you get started ensure that you:

1.

Connect signal source to Channel 1 and Channel 2 using XLR connectors 

(the amplifier inputs will automatically be summed together when 
selecting this preset).

2.

Connector the speaker as shown.

a.

If using the binding post outputs, connect the positive terminal of the speaker to the positive terminal of Channel 1 and 
the negative terminal of the speaker to the positive terminal of Channel 2.

b.

If using a Speakon

®

 connector, connect the positive terminal of the speaker to 1+ and the negative terminal to 2+. Plug the 

connector into the Channel 1 output only.

Follow these quick steps to configure the amplifier for 

BRIDGE

 operation:

1.

Push the “Set/Enter” button and you will see the word “Preset” flashing.

2.

Push the “Set/Enter” button again to enter the list of presets in the amplifier.

3.

Push the “Next/Down” or “PREV/UP” button until the screen displays “Bridge”.

4.

Push the “Set/Enter” button to confirm your selection.

5.

The display will now read “Bridge” with the Y icon and Bridge icon highlighted.

Get Started

XTi 6002 back panel shown.

See page 9 for XTi 1002, 
2002 and 4002 back panel.

NOTE: Custom wiring should 
only be performed by qualified 
personnel.

WARNING: Before you start to set up your 
amplifier, make sure you read and observe 
the Important Safety Instruc tions found at 
the beginning of this manual.