Programming a Button- Page 389

uu

HomeLink

®

 Universal Transceiver

*

u

Training HomeLink

388

Features

■

Programming a Button

1

Training HomeLink

Reprogramming a Button
If you want to retrain a programmed button for a 
new device, you do not have to erase all button 
memory. You can replace the existing memory code 
using this procedure:

2.

1.

Press and hold the desired HomeLink button until 
the HomeLink indicator begins to 

slowly flash 

orange

. This should take about 20 seconds.

Release the HomeLink button and position the 
remote transmitter you wish to link 1 - 3 inches 
(3 - 8 cm) from the HomeLink button you want to 
program, then follow steps 3 - 6 under 
“programming a button.”

Erasing Button Memory
To erase programming from the buttons, press and hold 
the two outside HomeLink buttons until the HomeLink 
indicator changes from 

orange to rapidly flashing green

. 

This should take about 10 seconds. You should erase all 
programming before selling the vehicle.

Operating
To operate, simply press and release the programmed 
HomeLink button. Activation will now occur for the 
trained device.

Questions
For questions or comments, visit 

www.HomeLink.com

, 

www.youtube.com/

HomeLinkGentex

, or by calling the HomeLink Hotline 

(North America only) at (800) 355-3515.

HomeLink

®

 is a registered trademark of Gentex 

Corporation.

Training 
Complete

HomeLink LED is 

continuously on green

.

YES

YES

1.

Position the remote transmitter you wish to link 1 to 3 inches (3 - 8 cm) from the 
HomeLink

®

 button you want to program.

3b.

Canadian Garage Door Opener

A. Press and release the HomeLink 
button. Press, hold and release the 
button on the remote every 2 secs. 
Does the HomeLink indicator (LED) 
change from 

slowly flashing orange to 

rapidly flashing or continuously on 
green

? The process should take less 

than 60 seconds.

NO

2.

Press and hold the desired HomeLink button. Is the HomeLink indicator (LED) 

slowly 

flashing orange

? 

NO

3a.

Hold the button on the remote 
transmitter. Does HomeLink indicator 
(LED) change from 

slowly flashing 

orange to rapidly flashing green or 
continuously on green

? The process 

should take less than 60 seconds.

5.

Press and hold the HomeLink button again.

HomeLink indicator 

rapidly flashes 

green

.

5a.

The remote has a rolling code. Press the 
“learn” button on the remote-controlled 
device (e.g. garage door opener).

6.

Press and hold the HomeLink button 
again.
The remote-controlled device should 
operate.

Training Complete

5b.

Within 30 secs, press and hold the 
programmed HomeLink button for 2 
secs.

4.

Press and hold the programmed HomeLink 
button for about a second. Does the device 
(garage door opener) work?