Honda Sensing- Page 513

uu

Honda Sensing

®

u

Adaptive Cruise Control (ACC) with Low Speed Follow

512

Driving

■

Automatic cancellation

The beeper sounds and a message appears on the driver information interface when 
ACC with Low Speed Follow is automatically canceled. Any of these conditions may 
cause the ACC with Low Speed Follow to automatically cancel:

•

Bad weather (rain, fog, snow, etc.)

•

The vehicle ahead of you cannot be detected.

•

An abnormal tire condition is detected, or the tires are skidding.

•

Driving on a mountainous road, or driving off road for extended periods.

•

Abrupt steering wheel movement.

•

When the ABS, VSA

®

, CMBS

TM

 or Low Speed Braking Control

*

 is activated.

•

When the VSA

®

 system indicator comes on.

•

When the vehicle is stopped on a very steep slope.

•

When you manually apply the parking brake.

•

Water is sprayed by or snow blown from a vehicle ahead.

•

Driving into low sunlight (e.g., at dawn or dusk).

•

When the detected vehicle within the ACC with Low Speed Follow range is too 
close to your vehicle.

•

When accelerating rapidly.

•

The front of the camera is covered by dirt, fog, rain, mud, wet snow, seals, 
accessories, stickers, or film on the windshield.

•

The vehicle is loaded heavy load in the trunk or rear seats.

•

When passing through a dark place, such as tunnel.

•

When the parking brake and brake system indicator (amber) comes on.

•

The vehicle has repeatedly applied the brakes to maintain the set speed (for 
example, you are descending a long slope).

•

When the system doesn't detect any driving actions from the driver for a certain 
amount of time while the LKAS is also activated.

The ACC with Low Speed Follow automatic cancellation can be also triggered by the 
following causes. In these cases, the parking brake will be automatically applied.

•

The driver’s seat belt is unfastened when the vehicle is stationary.

•

The vehicle stops for more than 10 minutes.

•

The engine is turned off.

1

To Cancel

The set speed cannot be set or resumed when ACC 
with Low Speed Follow has been turned off using the 

 button. Press the 

 button to activate the 

system, then set the desired speed.

Models with A-type meter

Prior Set Speed (gray)

 (white)

Models with B-type meter

Prior Set Speed (gray)

 (white)

* Not available on all models