Using Automatic Locking Mode; Essential Safety Equipment; Child Restraint- Page 69

Only use a tether anchor designed for the
second-row seats:

Using a third-row seat tether anchor on the
second-row seat is dangerous. The
child-restraint system cannot be installed
correctly which may result in death or
injury to the child in a collision.

Tether strap

Third-row seat

Second-row 
outboard/center 

Always route the tether straps to the sides
of the head restraint (Third-row seat):

Routing the tether straps on top of the
head restraint is dangerous. In a collision
the tether straps could slide off the head
restraint and loosen the child-restraint
system. The child-restraint system could
move which may result in death or injury to
the child.

Tether strap

Forward

Third-row seat

▼

Using Automatic Locking Mode
(Except Mexico)

Follow these instructions when using a
child-restraint system, unless you are
attaching a LATCH-equipped
child-restraint system to the rear LATCH
lower anchors. Refer to “Using LATCH
Lower Anchor” (page 2-64).

NOTE

Follow the child-restraint system
manufacturer's instructions carefully. If
you are not sure whether you have a
LATCH system or tether, check in the
child-restraint system manufacturer's
instructions and follow them accordingly.
Depending on the type of child-restraint
system, it may use LATCH system instead
of seat belts or if the belt goes across the
child's chest, may recommend against
using automatic locking mode.

1.

(Second-row seat)

Adjust the second-row seat position
using the following procedure.

 Fold the second-row seatback

forward.

 Raise the second-row seatback until

a click sound is heard and it is locked
in place.

2. Adjust the angle of the second-row

seatback so that there is no gap

Essential Safety Equipment

Child Restraint

2-57

CX-9_8JK1-EA-20G_Edition2_old

2020-7-20 17:31:45