Essential Safety Equipment; Child Restraint; Use the tether and tether anchor only for a- Page 70

between the child-restraint system and
the second-row seatback.

3. Make sure the seatback is securely

latched by pushing it back until it is
fully locked.

4.

(Second-row seat)

Remove the head restraint. However,
when installing a backless booster seat,
always install the vehicle head restraint
to the seat where the backless booster
seat is installed.
Refer to Head Restraints on page 2-28.

5. Secure the child-restraint system with

the lap portion of the lap/shoulder belt.
See the manufacturer's instructions on
the child-restraint system for belt
routing instructions.

6. To get the retractor into the automatic

locking mode, pull the shoulder belt
portion of the seat belt until the entire
length of the belt is out of the retractor.

7. Push the child-restraint system firmly

into the vehicle seat. Be sure the belt
retracts as snugly as possible. A
clicking noise from the retractor will
be heard during retraction if the system
is in the automatic locking mode. If the

belt does not lock the seat down tight,
repeat this step.

NOTE



Inspect this function before each use
of the child-restraint system. You
should not be able to pull the
shoulder belt out of the retractor
while the system is in the automatic
locking mode. When you remove the
child-restraint system, be sure the
belt fully retracts to return the
system to emergency locking mode
before occupants use the seat belts.

8. If your child-restraint system requires

the use of a tether strap, refer to the
manufacturer's instructions to hook
and tighten the tether strap.

WARNING

Use the tether and tether anchor only for a
child-restraint system:

Using the tether or tether anchor to secure
anything but a child-restraint system is
dangerous. This could weaken or damage
the tether or tether anchor and result in
injury.

Essential Safety Equipment

Child Restraint

2-58

CX-9_8JK1-EA-20G_Edition2_old

2020-7-20 17:31:45