Passenger Occupant Classification; Essential Safety Equipment; Child Restraint- Page 73

Do not allow a child or anyone to lean over
to or against the side window of a vehicle
with side and curtain air bags:

It is dangerous to allow anyone to lean
over to or against the side window, the
area of the front passenger seat, the front
and rear window pillars and the roof edge
along both sides from which the side and
curtain air bags deploy, even if a
child-restraint system is used. The impact
of inflation from a side or curtain air bag
could cause serious injury or death to an
out of position child. Furthermore, leaning
over to or against the door could block the
side and curtain air bags and eliminate the
advantages of supplemental protection.
Because the front seats are equipped with
front air bags, the rear seat is always a
better location for children. Take special
care not to allow a child to lean over to or
against the side window, even if the child is
seated in a child-restraint system.

Always remove the head restraint and
install child-restraint system (except when
installing a backless booster seat):

Installing a child-restraint system without
removing the head restraint is dangerous.
The child-restraint system cannot be
installed correctly which may result in
death or injury to the child in a collision.

Always install the head restraint and adjust
it to the appropriate position after
removing the child-restraint system:

Driving with the head restraint removed is
dangerous as impact to the occupant's
head cannot be prevented during
emergency braking or in a collision, which
could result in a serious accident, injury or
death.
Refer to Head Restraints on page 2-28.

Front Passenger's Seat Child-Restraint
System Installation (With Front
Passenger Occupant Classification
System)

1. Make sure the ignition is switched off.
2. Slide the seat as far back as possible.

3. Remove the head restraint. However,

when installing a backless booster seat,
always install the vehicle head restraint
to the seat where the backless booster
seat is installed.

4. Place the child-restraint system on the

seat without putting your weight on the
seat and fasten the seat belt. See the
manufacturer's instructions on the
child-restraint system for belt routing
instructions.

5. To get the retractor into the automatic

locking mode, pull the shoulder belt
portion of the seat belt until the entire
length of the belt is out of the retractor.

6. Push the child-restraint system firmly

into the vehicle seat. Be sure the belt
retracts as snugly as possible. A
clicking noise from the retractor will
be heard during retraction if the system
is in automatic locking mode. If the
belt does not lock the seat down tight,
repeat the previous step and also this
one.

Essential Safety Equipment

Child Restraint

2-61

CX-9_8JK1-EA-20G_Edition2_old

2020-7-20 17:31:45