Your Vehicle; Detection Areas; BLIND SPOT MONITORING (BSM) (if equipped)- Page 15

14

Blind Spot Monitoring (BSM)

Your Vehicle

Detection Areas

BLIND SPOT MONITORING (BSM) (if equipped)

The Blind Spot Monitoring (BSM) system is designed to assist the driver 
by monitoring blind spots on both sides of the vehicle to the rear in 
certain situations such as when changing lanes on roads and freeways or 
reversing the vehicle from a parking garage.

Turning BSM System Off

Turning the BSM system off will turn off both the light and sound 

indicators. To manually turn the BSM system off, push the BSM 

OFF switch on the dash. The BSM OFF indicator will illuminate 

in the instrument cluster when the BSM system is off. The BSM 

system will automatically turn on the next time the vehicle is started.
  •   If your vehicle speed is 6.7 mph (10.8 km/h) or more, the BSM will warn 

you of vehicles in the detection area by illuminating the BSM warning 

lights located on the left and right door mirrors.

  •   If you operate a turn signal in the direction of an illuminated BSM warning 

light, the system will also warn you with a beep and warning light flash.

  •   BSM sensors are located under the left and right rear bumper areas. The 

BSM system may not operate properly if the rear bumper gets too dirty, 

so keep the rear bumper area clean.

NOTE: 

Do not rely completely on the BSM system and be sure to look over your 

shoulder before changing lanes: 
 •  The BSM can assist the driver in confirming the safety of the surroundings, but 

is not a complete substitute. 

 •  The driver is responsible for ensuring safe lane changes and other maneuvers. 
 •  Always pay attention to the direction in which the vehicle is traveling and the 

vehicle’s surroundings. 

 •  The BSM does not operate when the vehicle speed is lower than about 6.7 mph 

(10.8 km/h).